| |
- The front of the truck should be raised on
mounts
- The inside of the truck should be
completely empty of all straw and fecal material
- Bag or move the straw and fecal material
away from the truck cleaning area
- Remove all removable equipment from the
inside of the truck
- Place a garden sprinkler inside the truck,
connect to the water mains and turn on for at least 30 minutes
- Soak all removable equipment for 5 minutes
- Spay detergent using a low pressure washing
(300 psi 30 bar) or the foam gun application at the required
concentration
- Allow detergent contact time of 30 minutes
- Using a pressure washer set at 500 psi (35
bar) with an 45o angle jet clean all removable equipment
- Allow to dry for 1 hour and then disinfect
at the required concentration
- Spay detergent inside the truck using a low
pressure washing (300 psi 30 bar) or the foam gun application
at a concentration of 2%
- Allow detergent contact time of 30 minutes
- Using a pressure washer set at 500 psi (35
bar) with a 45o angle jet clean the inside of the truck. Start
at the roof, work down the walls to the floor working towards
the back of the truck
- Allow the inside to dry for 1 hour and then
disinfect at the required concentration using a knapsack
sprayer
- Wet the the outside of the truck with water
from a hose or pressure washer set at 300 psi (30 bar)
- Spay detergent using a low pressure washing
(300 psi 30 bar) or the foam gun application at the required
concentration
- Allow detergent contact time of 30 minutes
- Pressure wash at 300 psi (30 bar) the
outside of the truck with water, starting at the roof, sides
and finally underneath. Pay particular attention to the wheels
and wheel flaps
- Disinfect the exterior of the truck with
disinfectant at the required concentration
- Complete the vehicle cleaning log book
|
|
|
|
